More Antenna Instalations

I awoke nice and early on Sunday morning, walked the dog and then listened to the local RSGB news broadcast as usual.

Straight after the weekly news broadcast, I headed outside and began installing a CAROLINA WINDOM 80 (133FT offset dipole).

The CW-80 tunes nicely from 80M to 10M and after listening around the bands for a short while yesterday, it seems to be performing well on 40M, 17M & 15M. I will be testing it further on the rest of the bands and recording the results.

The CW-80 is suspended between the House and a reasonably tall tree at the far end of the garden, as seen in the picture.
I shall be fixing the CW-80 higher up once I install a mast on the rear of the house which will help elevate the wire high above the roof.

The next job was to begin work on the Satellite antenna array that I am planing to use. I began by asembling the two antenna systems that I will be using, a 5 element 145MHz Yagi and a 30 element 435MHz X beam. I built both antennas up to a stage that can be completed when I am ready to finish the installation.

The next stage was to get the Yaesu GS5500 Azimuth/Elevation rotator set up. I wanted to check it and get it ready to be at hand for when I am at the construction/assembly stage.

Now, the not so fun part! Yes this was the part when the hard work started.

I began runing 2 control cables and 2 coaxial feeders from out in the garden to back inside the shack. (located at the opposite side of the house = Sods Law!).
I ended up spending a few hours doing the job of running the cables making sure that all cables were as neatly installed as possible. Finally I reached the back of my Yaesu FT-847 and GS5500 Azi/Ele Control unit, there I tinned/soldered the wires and connected them up ready for the outdoor work.

I finished yesterdays antenna antics off by identifing which coaxial feeder was which, I did this simply by using a electronic test multi meter held across the SO plug connector at the shack end of the coax . At the other end I attached an old antenna socket shorted out with a croc link lead to the end of one feeder that I had suspected to be for 145MHz.

All I need now is some more spare time and a pair of good ladders so I can fit the Satellite antennas up on the house with some nice heavy brackets that I made a while ago.

Comments

Anonymous said…
Installing the best kind of antenna to have better reception is somehow difficult. It takes a lot of time in to have it perfectly done. Anyway, have you tried using an antenna with a brass sheet? I'm using it as of now and it's really great, my reception for both TV and radio are clear.

Popular posts from this blog

Full Size Delta Loop for 20M

Homebrew 40/80 Trap Dipole Design

New DX Contact 0n 12 Meters