A YLs Guide to Christmas Gifts by M3TLL - Louise

-
Living with a radio ham means you instantly have ideas for Christmas gift buying. If you want to buy your radio amateur a hobby themed gift here are a few ideas you might want to consider.

Ideas for Stocking Fillers

* Anything with his callsign on it
I can't begin to describe the joy on 2E0HTS's face when he received through the post from an Slovenian ham friend (S57CW/S57ORG) a miniature Slovenian registration plate with his callsign on it. I can only assume the same would apply for any merchandise with his callsign written on it. A mug, a tshirt, a woolly hat for his DXpeditions. The possibilities are pretty much endless.

* Earphones
If, like me, occasionally you want some peace and quiet from the endless CQ calls and other amateurs tuning up then why not invest in a good pair of earphones. He'll think you care, you'll be able to watch telly in peace! Happy Christmas!

* Stationery
A radio ham always needs something to scrawl on and with. I learnt early on not to leave any important documents within a 10 metre radius of the ham shack as they're likely to come back with random callsigns, names and signal reports written on. Why not buy him some nice writing equipment of his very own to show him you care this festive season?

Big presents

If you're wanting to spend a bit more on the ham in your life then the list is simple: radio, antenna, atu, power supply, microphone. Last year 2E0HTS was lucky enough to get an FT-817 from Santa. If you are going to buy something like this make sure you either buy new from a supplier like Waters and Stanton. Or, if you are wanting to go second hand ask another (trustworthy) radio ham to help you choose something. Some second hand equipment can be used and abused and the last thing you want on Christmas day is a radio ham with a present that doesn't work.

These are just a few ideas you might want to consider. Maybe some readers have other ideas? If so pop them in the comments below (I still don't know what to get 2E0HTS this year!!)

Louise M3TLL

Comments

Unknown said…
I've got an idea Louise:
A pair of earplugs. ;)
Simon should find them useful sometimes in a few months... (baby's cries). hi hi

All the best to you 2.

Cyril
F4FUL
1:23 pm
Phaze58 said…
I think you have got him the best pressie EVER a HOUSE to put antennas on ! what could be better than that?
no seiously I think a nice Framed picture of him doing what he loves doing would go down a treat.

Have a Verry Merry (warm) Christmas this year .Hope to see ya both before the year is out
regards Phil XXX & BaronTheDog woof!
10:15 pm
SimonF said…
If Santa is feeling flush then a video recorder to grab those QSOs will keep the blogs full of exciting YouTube clips...

http://www.theflip.com/en-gb/

M0TGT Simon
5:08 am
Post a Comment

Popular posts from this blog

Full Size Delta Loop for 20M

-
Image
I came across a simple delta loop design courtesy of dxzone found on the net some time ago and have been planning to give it a go for a while. This weekend I had a couple of hours spare, so I decided to give it a go using some 2mm multi strand wire cable, a dipole centre and a mixture of 75 ohm and 50 ohm coaxial cable. The delta loop is supposed to be resonant on 20 meters but I found it to be a little high so at present I am tuning the Loop with my mfj-969 which copes extremely well. The resonant frequency is 13.2 MHz at the moment so the next chance I get, I shall shorten the overall length making sure that each of the three sides are still equal in length, and hopefully adjusting the antenna for maximum performance ATU free for 14.2 MHz. I believe the miscalculation in the resonant length is probably down to the fact that my wire is covered in the plastic sleeving from the manufacturer which always effects the swr as I have noticed in past experiments with dipoles you always get sl...
Read more

Homebrew 40/80 Trap Dipole Design

-
Image
This Antenna design was one that I used about 4 years ago, it worked exceptionally well on 80m and 40m. The size of the antenna makes a Half wave length on 80 meters, and with the traps a half wave on 40m with a SWR (standing wave ratio) of 1:1-1.5 across both bands. It worked well also on 20m with the use of an A.T.U (antenna tuning unit). I made my version of this antenna using 3mm multi strand copper cable which I left covered by the PVC insulation. The traps can either be home brewed using some 40mm diameter plastic drain pipe and winding wire around the pipe approximately 10 turns, then connected in line after the 10 metre lengths. Or the alternative is to purchase some commercially made 7.1 MHz traps, and fit them in line the same way. The antenna can be fed with 50 ohm coax with a home brew balan or again a commercially purchased balan. The wire lengths of the dipole are 2x 10 metres and 2x 6.7 metres as shown on the diagram above. This antenna can be mounted quite low to the gr...
Read more

YAESU G - 5500 Elevation Rotator Repair

-
Image
After 10 years of careful use my G-5500 eventually developed a couple of faults on the elevation rotator side.  Fault 1. For the past year I have had to guess the elevation as the readout was no longer working on the controller unit. I suspected the position switch which was located inside the rotator up above the house roof which was a pain in the butt to say the least. Fault 2. Over the winter the gearbox on the elevation rotor seized up solid. I plucked up some courage and erected my ladder and which with the aid of a rope to lower the mast it all worked out quite straight forward. Once down out with the impact driver and away I went. Once I split the case with the impact driver which was easy, I found lots of sandy grit and dried out remains of what should have or once was gearbox/bearing grease. The next step was to inspect the seized gearbox and then remove the main shaft which can only be carried out by first removing the entire gear housing u...
Read more