Home Made Radials & Connecting Bracket
Despite another weekend of poor WX, I was determined to get started with the radial installation that I have been working on for use with my Hustler 6BTV antenna. I decided to start with radials cut for 20M and wanted each radial to be 1/2 wave lengths. I set about the second stage of the task by measuring four lengths of 2mm diameter wire and cutting them all the same. The four wire radial lengths were all cut at 34ft. I soldered small lugs on each end of the four wire radials, which I screwed to the brass stakes and brass mounting bracket (as seen in the previous post). To do this I used stainless steel self tapping screws. The image below shows the mounting bracket installed. It is located directly beneath the Hustler 6BTV feed point. The radial bracket is clamped around the ground stake as well as having a seperate short connecting wire fed directly from the antenna to the brass radial bracket. I will be adding more radials for 40m and other bands next time I get a couple of hours